CIRCUIT buoy

The series is a series of buoys which is widely used general angler, because the detection signal readability. Buoy installation is fairly easy when used special pins and rubber buoy special delimiter (stopper), which makes circuit had to be practical in your fishing rod. At first loloskan kenur kenur on track in the rod, insert rubber sequential divider, pin floats, rubber barrier, the last tin of beans pepper tie pin (link swivel) at the end kenur. The series of buoys is very suitable to be applied on calm water or windy'm with a maximum depth of 2 meters. Measuring the depth of water must be right that a buoy with the bait was not too long which can make the fish escape during fishing rod subjected digentak, do not also too short so that the buoy sinking or floating bait. Throw the bait into the waters, roll kenur a little, dip the rod tip into the water kepretkan rod until kenur become submerged due to kenur which will float or drift in the wind. Choose the deepest area in the fall of the throw by moving bit by bit until the buoy rather drown. Note floats carefully, distinguish motion due to buoy the wind, or drift fish tersenggol. The movement of the bait rod float is being eaten is toward the bottom, watch out for immediate menggentak rod entirely submerged when the buoy. Stamping rod to the rear with a bang. Begin your next game that is menakalukkan fish was hooked.